The manual is embedded in the build instructions for the various Align kits. This appears to come out of the manual. At least its identical to. i have just ordered an Align 3gx flybarless control unit but i can’t find any instructions online anywhere as i like to usually download and print. Align 3Gx flybarless setup problem Electric Heli Talk. Registered User Without the 3Gx module in place, with servos connected directly to.
|Published (Last):||4 September 2008|
|PDF File Size:||13.92 Mb|
|ePub File Size:||17.88 Mb|
|Price:||Free* [*Free Regsitration Required]|
There is a direct correlation between servos’ speed to gyro’s performance. If needed, servo reverse is done from the transmitter’s REV reverse function.
Press the SET button to enter A.
At least its identical to my manual that starts on page Problem solved — the manual is wrong!! We are majual from the same manual. Lift up the helicopter by hand, and turn it to the left yaw. Register Now In order to be able to post messages on the HeliFreak forums, you must first register.
The goal is to find the maximum gain without tail hunting. Jul 06, Custom parameters have been opened up in 3GX to allow manaul to fine tune numerous settings for swashplate and rudder.
Align 3gx pdf manual
Push the throttle stick on transmitter to the maximum top, and in a 3hx moments LED will go off and system power cycles, indicating the completion of setup process. Are there pages missing? I know I might have figured that was wrong earlier, but I’m new to fbl and was concentrating on getting the colours exactly in the order shown in the manual.
Just leave the servo horns off until your in setup and install them as close to level as poss at mid stick. You need to pick servo type before even connecting the servos or you have the potential to damage them.
Def hook up power to the unit, get a usb extension cable and hook it to your pc and it almost walks you through the setup process. Pay extra manua, to these setup steps.
Please click one of the Quick Reply icons in the posts above to activate Quick Reply. Confirm the transmitter is powered up, and throttle stick is at lowest position.
3GX Flybarless System – Download – Align
Push and hold the SET button for 2 second to enter the rudder gyro setup mode while 3GX is turned on. Feb 04, This setup mode sets the elevator gyro direction. Due to the high performance gyro sensors used in the 3GX flybarless system, premium high speed digital rudder servos are mandatory for optimal tail performance.
With the APS gyro, the helicopter will have the ability to self stabilize, hold position as well as altitude, and even autonomous way point flights as well as return home.
Press the SET button to enter E. Align 3Gx flybarless setup problem. Tilt the helicopter right as shown in diagramand check if swashplate is tilting correctly toward the left. This is clearly noticeable in stable hover as well as highly aerobatic routines.
I also found allgn site: In the next section, for S. Well done eban I didn’t spot the mistake and the problem nearly brought my very short experiment with FBL to an untimely end. The dramatically improved performance will create immediate impact on any enthusiasts.
Adjust the servo neutral point and main blade pitch. Are you sure you don’t remove the bind plug after powering down? In mine the section on RFS connection middle of page only says, “Care should be taken to ensure proper wire color to channel connection.