Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C/CM: Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout.

Author: Tygoran Naramar
Country: Angola
Language: English (Spanish)
Genre: Relationship
Published (Last): 21 December 2009
Pages: 434
PDF File Size: 18.90 Mb
ePub File Size: 2.88 Mb
ISBN: 974-5-33467-736-8
Downloads: 66630
Price: Free* [*Free Regsitration Required]
Uploader: Akinozragore

[email protected]: Testing of shrinkage for concrete – grout.

Aatm alternative designation given in parentheses is for information only and does not represent a different standard sieve size. The degree of restraint varies with the mixture viscosity and degree of hardening. The height change results in both test methods are expressed in terms of percentage increase or decrease of the original specimen height.

After removal, the thickness of the glass plate was measured with a caliper at the points of contact between the glass plate and the micrometer.

An exception is made when the options described in the section on test conditions are exercised. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

  BORIS VIAN A ESPUMA DOS DIAS PDF

ASTM C1090

This thickness was then added to the four-reading initial measurement. Aetm size is identified by its standard designation in Specification E Two cylindrical specimens with the same dimensions as those used for the ASTM C test method were prepared in which the change in height was measured at four points on the top surface of the specimens using a micrometer in accordance with ASTM C at 1, 3, 7, 14, and 28 d see figure awtm Combining values from the two systems may result in non-conformance with the standard.

The glass plate was removed from the top of the test specimen after 24 h. The laser approach has been compared with the original setup, and similar results were obtained. Historical Version s – view previous versions of standard.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. This approach provided more simplicity in the execution of the test, rather than using a projector lamp, magnifying lens, and indicator charts c1009 described in ASTM C see figure For cementitious grouts, saturate the surface up to SSD.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The height change of a 3-inch mm -diameter by 6-inch mm -tall cylindrical specimen was measured in accordance with ASTM C Testing of shrinkage for v1090 – grout.

  CONSTRUIR MARCAS PODEROSAS AAKER PDF

Some values have only SI units because the inch-pound equivalents are not used in practice. Though not recommended by the ASTM standards, and in order to provide the lowest friction possible, an acetate sheet was used in between the test specimen and the mold. In both test methods, there is always a certain degree of friction between the specimen’s sides and the inner surface of the metallic mold. I married on 30 th June now having one b Link to Active This link will always route to the current Active version of the standard.

Newer Post Older Post Home. These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-s