AT90S, AT90S Datasheet, AT90S Pin 8MHz 8kb 8-bit Microcontroller, buy AT90S Disclaimer: Whilst information is supplied in good faith, we are not liable for any errors or omissions. Please consult the relevant Atmel datasheet. E&OE. The AT90S is a low-power CMOS 8-bit microcontroller based on the AVR RISC By executing powerful instructions in a single clock cycle, the AT90S

Author: Mikagul Malatilar
Country: Brazil
Language: English (Spanish)
Genre: Music
Published (Last): 20 September 2007
Pages: 33
PDF File Size: 2.60 Mb
ePub File Size: 9.42 Mb
ISBN: 314-1-77531-390-8
Downloads: 15554
Price: Free* [*Free Regsitration Required]
Uploader: Kajikora

I would buy my own AT90S and try to debug this with you, but it seems like it at90s853 pretty hard to buy the AT90S online, and according to Atmel, that chip is a mature product and not recommended for new designs. I have also tried with avrdude, it gives me: I have checked the voltage settings, and tried many combinations.

Datasheet «AT90S8535»

Recent History What is this? Month Sales Transactions. I have not tested any other controllers, as I have a stock of about s. What kind of clock or crystal is the AT90S connected to? STK never failes at all.

All the 32 registers are directly connected to the Arithmetic Logic Unit ALUallowing two independent registers to be accessed in one single instruction executed in one clock cycle. Shop Blog Forum Support. When you place an order, your payment is made to SeekIC and not to your seller. In that section, it says: I looked at the two datasheets wide by side and the only difference I can see in the text and the drawing is that on the the RESET pin is shown to be connected to GND!

  LEGO 6380 INSTRUCTIONS PDF

AT90S Datasheet(PDF) – ATMEL Corporation

The resulting architecture is more ddatasheet efficient while achieving throughputs up to ten times faster than conventional CISC microcontrollers. The complete avrdude command is: The frequency matters too, so what frequency is the clock or crystal?

Faithfully describe 24 hours delivery 7 days Changing or Refunding. SeekIC only pays the seller after confirming you have received your order.

If you want to look at the programming lines on an oscilloscope and diagnose the problem, that might allow me to make a firmware update that fixes the problem, but you datasgeet probably just use the programmer you have that works.

You may also be interested in: Unfortunately, I do not know what might be going wrong. I tried changing the crystal to 8MHz, and it did not help, could it be that the delay before the AVR responds is too short for the old controllers?

Thank you for your fast reply! I am reading the AT90S datasheet and trying to determine what might be going wrong. The on-chip ISP Flash allows the program memory to be reprogrammed in-system through an SPI serial interface or by a conventional nonvolatile memory programmer. In Power Save mode, the timer oscillator continues to run, allowing the user to maintain a timer base while the rest of the device is sleeping.

  FROM LOWBROW TO NOBROW PDF

We will also never share your payment details with your seller. We have not tested the dataeheet with the AT90S and I do not know of any customers who have done that either, so there might be trouble getting it att90s8535 work.

In that section, it says:.

Margin,quality,low-cost products with low minimum orders. Freight and Payment Recommended logistics Recommended bank. The Power Down mode saves the register contents but freezes the oscillator, disabling all other chip functions until the next interrupt or hardware reset. Please create an account or Sign in. I tested a board I found with an megaL, and it worked perfectly.