H-REAP Design and Deployment Guide – Cisco Learning Read more about controller, lwapp, configuration, wireless, configured and wlans. HReap Design and Deployment Guide: /products_tech_noteashtml Configuring Hybrid REAP. 27, 24, , 2/8/, Wireless LAN IPv6 Client Deployment Guide New! 55, 14, , 6/29/, H-Reap Design and Deployment Guide.

Author: Jut Zololkis
Country: Gambia
Language: English (Spanish)
Genre: Business
Published (Last): 12 April 2005
Pages: 96
PDF File Size: 20.34 Mb
ePub File Size: 3.4 Mb
ISBN: 681-2-71968-284-4
Downloads: 22659
Price: Free* [*Free Regsitration Required]
Uploader: Yozshurn

And we are noticing the loop in to the network? Should we be expecting seamless fail-over in this scenario?

Andrew vonNagy July 29, at 9: Yes, you should make the configurations identical on both controllers, except for things that must be different like interface IP addresses.

Here is a link from cisco. Local controller at remote site is primary controller for the APs at remote site and centrally located controller is secondary controller for the APs at remote gukde.

Revolution Wi-Fi: H-REAP Deployment Guidelines and Feature Limitations

Anonymous July 2, at Andrew vonNagy December 13, at 2: Kristjan, No deployjent is replicated between feployment. First, authentication timers on clients; they expect to have authentication complete within a reasonable amount of time, and if not then they will assume it has failed and try to reconnect and start the authentication process over. Hi Andrew, Great post with an awesome summary! We have tried to do load sharing by dividing groups to both controller.

  FRETBOARD ROADMAPS COUNTRY PDF

I can be reached at samuel. I have not yet evaluated the Aerohive solution, but have some gear that I will be looking at soon. In case of fail over if they go from group of one controller to default group of other, what will be impact? guidf

If you continue to run annd troubles, you should call Cisco TAC to investigate. Am I right about that? You would have to manually configure the information on both.

What is H-REAP mode?

Curious about your thoughts on the controller-less solution from Aerohive? But it’s still fairly manual. Anonymous August 24, at 7: Hi Andrew, Thanks for the post.

Andrew vonNagy December 13, at 6: I must admit though, I prefer your summaries to the matrix and release notes. Searching high and low for this but could not still get my hands on one. Anonymous March 16, at The AP hrep a response from the controller within 2 seconds, otherwise it sends up to 5 more hearbeat packets at 1 sec. Troy Martin June 10, at 5: This is still an open feature gap. Are you sure it is neccesary to add the APs manually to the secondary controller?

  BIEWENER ANIMAL LOCOMOTION PDF

First, several guidelines are recommended for successful deployment. We’re about to roll out wi-fi throughout our campus including remote sites and would like to use central authentication with local switching.

What is H-REAP mode?

Newer Post Older Post Home. Aerohive has an advantage because they were able to develop their drsign without existing product roadmaps and feature sets to support and upgrade along the way.

Seems like a refreshing approach. The WAN latency can affect the responsiveness of the heartbeat communications and can cause the AP to disconnect from the controller and go into standalone mode.