These topics include IPv4 and IPv6 network configuration, managing TCP/IP 1. Oracle Solaris TCP/IP Protocol Suite (Overview) The default is 10 seconds. Oracle Solaris Administration: IP Services Oracle Solaris 10 1/13 Information An IPMP configuration typically consists of two or more physical interfaces on the . For IPMP configuration tasks, refer to Chapter 31, Administering IPMP (Tasks). Oracle Solaris IPMP involves the following software: You can configure one of the interfaces down to 10 megabits and still place the two interfaces into the.

Author: Tegar Vogami
Country: Belarus
Language: English (Spanish)
Genre: Sex
Published (Last): 12 October 2007
Pages: 12
PDF File Size: 12.89 Mb
ePub File Size: 5.62 Mb
ISBN: 770-2-66321-595-1
Downloads: 50873
Price: Free* [*Free Regsitration Required]
Uploader: Zugor

How to configure Solaris 10 Probe based IPMP – The Geek Diary

Likewise for logical interface and test address. See Detecting Physical Interface Repairs for more information.

Depending on your failure detection requirements, you might need to either use specific types of network interfaces or configure additional IP addresses on each network interface. These interfaces and the data addresses that are configured on them are immediately available for use by the IPMP group.

solariz You need to configure a test address only if you want to use probe-based failure detection on a particular interface. If the system has additional interfaces on a second IP link, you must configure these interfaces as another IPMP group.

  INDUSTRIAL ECONOMICS R BARTHWAL PDF

For example, you would create the following test address for the primary network interface hme Test addresses are IPMP-specific addresses that are used by the in. Routers that are connected to the IP link are automatically selected as targets for probing.

Reboot the system after any changes to verify you have unique mac addresses now. You can use host routes to explicitly configure a list of target systems to be used by in. Repair detection assumes that you have enabled failbacks.

IPMP Configuration – Solaris 10 vs Solaris 11

This chapter contains the following information: For more information on link-local addresses, refer to Link-Local Unicast Address. You should receive a status message regarding this event. For example, a qfe NIC can eolaris four interfaces, qfe0 through qfe3and so on.

Solaris 11 IPMP confifuration two different methods for probe-based failure detection, the default method by using test addresses, and the transitive probing method without additional test addresses. However, hme0 does not have a test address configured. Thank you so much brother. Currently you have JavaScript disabled.

You can observe this flag in the status lines for the interface in the ifconfig output.

How to configure Solaris 10 Link Based IPMP

IPv4 test addresses do not need to be routeable. Configuring IPsec Tasks Probe traffic helps to determine the status of the interface and its NIC, including whether an interface has failed. In this instance, the test IPv4 address is configured only on the sklaris reboot.

  LEABHAR GABHALA PDF

Make sure the NIC status are up and not in use. Each interface can be configured with an IP test address.

The probing rate depends on the failure detection time FDT. Dynamic reconfiguration DR is the ability to reconfigure a system while the system is running, with little or no impact on existing operations. IPv6 in Depth Reference. Configuring netmasks and default gateway in zones Solaris This can be done in two ways. A single interface can be configured in its own IPMP group.

The first few hosts that respond to the echo packets are chosen as targets for probing. For example, you cannot place an ATM interface in the same group as an Ethernet interface. The standby interface in an IPMP group is not used for data traffic unless some other interface in the group fails.

These messages are informational in nature and indicate that the IPMP configuration functions correctly. IPMP also provides load spreading of packets for systems with multiple interfaces.