This is a Kenwood VHF repeater, model number TKR This is a 32 ch, 50 watt repeater that operates in the Mhz range. Repeater is capable of both. Find great deals for Kenwood Tkr Repeater VHF 16ch MHz 50 Watts. Shop with confidence on eBay!. TKR) TCXO modules, % duty RF power amplifier output is 50W (at 50 % duty) a TKR is 40W (at. 50% duty). make Kenwood’s TKR/
|Published (Last):||15 March 2010|
|PDF File Size:||16.61 Mb|
|ePub File Size:||3.99 Mb|
|Price:||Free* [*Free Regsitration Required]|
Clean, crisp audio kenwoor. We’ve had the pre amps and TRK’s in service about 2 years with no issues. Patent and other rights reserved. Specify DC current settings at time of order. We have ours set to 25 watts, since they can run nearly constantly in our type of link service.
TKRE – (Discontinued) — Kenwood South Africa
Item is an option and cannot be sold separately. Modem bps to be used with LTR controllers, includes interface cable. Otherwise it is a kenwoood nice machine. Could use a little more fan, but we have never had one go down. Includes two cables for radio connectivity and an internal antenna relay. Standard aluminum equipment rack providing 17 RU vertical mounting. Programmation is also a charm. Kenwood rates them at 25 watts continuous, and that seems accurate.
I agree the comment about purchasing the Kenwood TKR instead of building a repeater from parts.
Kenwood Tkr-750-1 Repeater VHF 16ch 146-174 MHz 50 Watts
Runs just fine and no heat issue. FM VHF repeater with cw controler build in. I will agree that the sensitivity could be better. These have a built in DTMF controller, which can be configured to control internal functions, or drive external accessories or relays. Take it out and you have the same sensitivity of the Kenwood. For use with voting systems, supplies Ohm balanced 2-wire audio, occupies 1 RU.
Excellent performance, even with less than optimal filtration Email Subscription You are not subscribed to this review.
We use these repeaters in commercial radio sites. The 25 pin connector gives you everything you need. Optional for situations where extra protection during transportation is required.
The system is sometimes keyed up for hours on end, kenwoo no problems. The only negative thing I found was that the audio level on the discriminator is extremely low. Modem bps, extra stability in high RF environments, includes interface cable.
Kenwood Tkr Repeater VHF 16ch MHz 50 Watts | eBay
Only one weak point: The UHF’s are around spec at. The only thing I can fault the Kenwood’s on is that the audio could pass a little more bass.
Includes equipment installation, hardware, cabling and kehwood management materials, and cushioned shipping crate. Plus why amplify noise before the duplexers? Do not use it. We have 7 of these repeaters on our linked repeater system, they have been operating flawlessly for 5 years or so. As others have noted, about the only alignment required is the helical front end in the RX. Set at 30 watts input to the duplexers.
However, since the TKR runs on 13,8 volts, it is easy to use just any heavy-duty power supply. The repeater puts out 35 watts. Just want to let folks know that hams may be better off getting the low split K2 version, just Tkd-750.
I wouldn’t put a pre amp up near an antenna for love or money. Audio is really good also.
That takes about 5 minutes to do, but should be done for best sensitivity. Cabinet Solid Floor Panel. Programmed repeater the on the bench and installed on site it has worked great without kenood changes.